Teamgroup’s T-Force G50 is an excellent combination of good (if not top-shelf) performance and penny-pinching affordability. It’s a great value for anyone who’s looking for a solid PCIe 4.0 drive for everyday tasks.
What are the Teamgroup T-Force G50’s features?
The Teamgroup T-Force G50 is a M.2, 2280 (22mm wide, 80mm long) NVMe PCIe 4.0 x4 sporting 176-layer 3D TLC NAND Flash governed by a InnoGrit IG5220 controller. It has a host memory buffer (HMB) design, meaning it uses your device’s memory rather than onboard DRAM as primary cache.
The G50 comes with removable thin graphene heat-spreader (seen in the image above) that, besides helping thermals, gives the module a sporty look.
Teamgroup warranties the T-Force G50 for a full five years, mitigated by the 650 TBW (terabytes that may be written to the drive) per 1TB of capacity. If you’re not familiar, TBW is like the miles in an automobile warranty. The average TBW rating in this category is 600TBW, though many like-priced QLC SSDs are only covered for 200 to 250 TBW.
How much does the Teamgroup T-Force G50 cost?
I’ve always wanted to create a website with one word or single-phrase product evaluations. In this case, that phrase would be “not very much.” Not very much as in $50 for 512GB, $70 for 1TB, and only $120 for 2TB (and right now, Amazon has them for even less). Yowser, folks! NVMe dropping to only $60 per terabyte? That’s even cheaper than the recently reviewed, and very affordable Kingston NV3.
How fast is the Teamgroup T-Force G50?
The G50 hardly jumped to the head of the PCIe 4.0 NVMe SSD class. But with all due respect to the fine art of benchmarking, even the most slothful student in this class is darn fast. Subjectively, except for the 450GB write, which is heavily dependent on the amount of NAND on board, you’d never be able to tell most NVMe SSDs apart in real-world use.
That said, there are faster PCIe 4.0 drives available (including the Crucial P310 and Corsair MP600 Elite in the charts). Sequential throughput in CrystalDiksMark 8 was the G50’s weakest test, if one could all over 4GBps weak.
The G50’s 4K numbers under CrystalDiskMark 8 were closer to those of the competition.
The G50 actually nudged in front of the rival Kingston NV3’s aggregate 48GB transfer time.
Having 2TB of NAND generally allows an HMB NVMe SSD such as the T-Force G50 to write our large 450GB file in a short amount of time: 2 minutes, 17 seconds is bookin’.
Below you can see what happens when the G50 finally runs out of cache. Most users will rarely copy a single 900GB file or experience this issue. This speed is indicative of older TLC. Only QLC will write slower natively (sans caching of any type).
